Futaba 3VCS - Manual (Page 43)

44
Functions
(Initial screen)
Use the or
button to select the
menu screen.
Press the button.
Use the or
button to select the
function.
Press the button.
Calling the setup screen
* When the direct call button is set,
the setup screen is also called by the
following method:
MENU SELECT
DIRECT SEL
Press the and
button simulataneously.
Press the button set
at this function.
* Calling from menu screen
Use the or button to
select the setup item.
* blinks at the current
setup item.
(Initial screen)
MENU
No TH-SPEED/Tires slip and vehicle does not move
TH-SPEED/Smooth, quick starts possible
* The LED blinks while the throttle
speed function is on.
* The black part of the bar graph is
the operation range.
* Throttle trigger position
* "L40" indicates operation below 40%.
Throttle speed/TH-SPEED (Throttle system)
Adjustment buttons
- Use the (+) and (-) buttons to make
adjustments.
- Return to the initial value by pressing
the (+) and (-) buttons simultaneously
(approx. 1 sec).
Setup items
RA NGE : Operation range
SPEED
: Speed amount
MODE : Function ON/OFF
Throttle speed/TH-SPEED (Throttle system)
Sudden trottle stick operation on a slippery road
only causes the wheels to spin and the vehicle can-
not accelerate smoothly. Setting the throttle speed
function reduces wasteful battery consumption
while at the same time permitting smooth, enjoy-
able operation.
Operation
Throttle servo (amp) operation is delayed so that the drive wheels will not spin even
if the trottle stick is operated more than necessary. This delay function is not per-
formed when the trottle stick is returned and at brake operation.
- Low side throttle speed (See [Operation range setup].)
Use when adjusting the speed from the neutral position to the set point.
- High side throttle speed (See [Operation range setup].)
Use when adjusting the high side speed from the set point.
Remark: Regarding the throttle speed set value; the actual delay value varies
depending on the system (HRS, PCM, PPM). The delay when the HRS system is used is approximately 1/
3 that of the PCM and PPM systems.
Operation display
The LED blinks while the throttle speed function is on.