Futaba 3VCS - Manual (Page 16)

17
Before Using
BT2
ATL
BT1
D/R
Digital Trim Operation
(Initial settings: DT1: Steering trim, DT2: Throttle trim, DT3: -------)
Push the lever in the arrow direction (up/down or right/left). The current position is
displayed on the LCD screen.
Steering trim display
Throttle trim display
(*1) For a description of how to display steering
EXP on the LCD screen, see page 99.
- Each step is indicated by a tone.
-When the trim exceeds the maximum trim adjust-
ment range, the tone will change pitch and the lever
will not move any farther.
Trim Operation
With the center trim feature, trim adjustments have no effect on the maximum servo
travel. This prevents the linkages from binding when adjustments are made.
DT2 DT3
DT1
BT1 BT2
ATL display
Steering D/R display
Button Trim Operation
(Initial state: BT1; Steering D/R, BT2; ATL)
Operate by pressing the button of the direction you want to set. The current set value
is displayed on the LCD screen.
- Each step is indicated by a tone.
- When the dial reaches the maximum or
minimum adjustment range, the tone will
change pitch and the dial cannot turn far-
ther.
- When both buttons are pressed simulta-
neously for about one second, the set value
returns to the initial value.