Futaba 3VCS - Manual (Page 66)

67
Functions
Mixing amount
-100~0~+100
Initial value: +50
Function ON/OFF
INH, ACT
Channel selection
ST, TH, CH3
Initial value: ST
Mixing mode
OFF, MIX
Initial value: OFF
Switch
PRG MIX1 : Program mixing 1
PRG MIX2 : Program mixing 2
Program mixing adjustment
(Preparation)
- Use the function select switch function (page ) to select
the switch. (as desired)
- Select setup item "MODE" and make the following ad-
justments.
1 (Function ON/OFF)
Set the function to the "ACT" state by pressing
the (+) or (-) button.
"INH": Function OFF, "ACT": Function ON
2 (Master channel)
Select setup item "MST" by pressing the (UP)
button twice, and select the master channel by
pressing the (+) or (-) button.
3 (Slave channel)
Select setup item "SLV" by pressing the (DN)
button once, and select the slave channel by
pressing the (+) or (-) button.
4 (Mixing amount adjustment)---upper item
Select setup item "LFT" etc. by pressing the (UP)
button three times, and use the (+) and (-) but-
tons to adjust the mixing amount.
5 (Mixing amount adjustment)---lower item
Select setup item "RGT" etc. by pressing the
(DN) button once, and use the (+) and (-) buttons
to adjust the mixing amount.
6 (Offset amount setup)
Select setup item "OFS" by pressing the (DN)
button twice, and use the (+) and (-) button to
adjust the offset amount.
7 (Mixing mode setup)
Select setup item "MXD" by pressing the (DN)
button once, and use the (+) or (-) button to se-
lect the mixing mode.
"OFF" : Mixing proportional to master channel operation.
"MIX" : Mixing by master channel another function considered.
Channel selection
ST, TH, CH3
Initial value: TH
Mixing amount
-100~0~+100
Initial value: +50
Offset amount
-100~0~+100
Initial value: 0
Program Mixing 1,2/PRG-MIX1,2