Futaba 3VCS - Manual (Page 56)

57
Functions
(Initial screen)
Use the or
button to select the
menu screen.
Press the button.
Use the or
button to select the
function.
Press the button.
Calling the setup screen
* When the direct call button is set,
the setup screen is also called by the
following method:
MENU SELECT
DIRECT SEL
Press the and
button simulataneously.
Press the button set
at this function.
* Calling from menu screen
Use the or button to
select the setup item.
* blinks at the current
setup item.
(Initial screen)
MENU
* The LED blinks while the Idle-Up
function is on.
* Idle-Up 1/2 on/off state.
( Warning display)
Idle-Up/IDLE-UP 1/2(Throttle system)
Use this function to improve the starting characteristics of the engine by raising the
idling speed when starting the engine of a gas powered car.
Operation
Offsets the throttle neutral position to the forward side or brake side.
Switch Setting
Select the idle-up function ON/OFF switch with the function select switch function.
(See page 82)
Operation Display
When this function is activated, the LED flashes.
If the power switch is turned on while the idle-up switch is
on, an audible alarm will be heard. Immediately set the
Idle-Up switch to OFF.
Adjustment buttons
- Use the (+) and (-) buttons to make
adjustments.
- Press the (+) and (-) buttons simulta-
neously (approx. 1 sec) to return to the
initial screen.
Idle-Up rate
D50% ~ D1%, 0%, U1% ~ U50%
Initial value: 0%
"D": Brake side
"U": Forward side
Idle-Up/IDLE-UP 1/2(Throttle system)
Idle-Up function adjustment
(Preparation)
- Use the function select switch function to select the
switch.
1 (Idle-Up rate)
Use the (+) and (-) buttons to set the Idle-Up rate.
2 When ending adjustment, return to the initial
screen by pressing the (END) button 3 times.