Futaba 3VCS - Manual (Page 65)

66
Functions
(Initial screen)
Use the or
button to select the
menu screen.
Press the button.
Use the or
button to select the
function.
Press the button.
Calling the setup screen
* When the direct call button is set,
the setup screen is also called by the
following method:
MENU SELECT
DIRECT SEL
Press the and
button simulataneously.
Press the button set
at this function.
* Calling from menu screen
Use the or button to
select the setup item.
* blinks at the current
setup item.
(Initial screen)
MENU
Program Mixing 1,2/PRG-MIX1,2
These functions allow you to apply mixing between the steering, throttle, and chan-
nel 3 channels.
Two programmable mixing systems can be used. The programmable mixing 1 and
programmable mixing 2 set-up screens are independent.
Additional Functions
-When the steering or throttle channel is the master channel (channel that applies
mixing), trim data can be added. (Trim mode)
- The mixing mode selection. (Master mixing mode)
- The master channel mixing center point (point at which the direction changes) can
be offset. (Offset fanction)
Movement of the slave channel side
The movement of the master channel side will be added to the movement of the slave
channel side.
Switch Setting
The programmable mixing 1,2 function ON/OFF switch can be set with the function
select switch function. (Page 82 ) SW1 or SW2 can be selected.
Dial / Trim Setting
The mixing rate amount can be controlled with button trim BT1, BT2 or digital trim
DT3, etc. with the function select dial function. (Page80)
Setup items
LEFT
: Mixing rate (Left side)
RGHT : Mixing rate (Right side)
MST
: Master channel
SLV : Slave channel
MODE : Function ON/OFF
OFST : Offset
MXMD : Mix mode
TRIM
: Trim mode
* These setup items are different de-
pend on the master channel.
Upper side : LEFT/FWRD/UP
Lower side : RGHT/BRAK/DOWN
Adjustment buttons
- Use the (+) and (-) buttons to make
adjustments.
- Press the (+) and (-) buttons simulta-
neously (approx. 1 sec) to return to the
initial screen.
Program Mixing 1,2/PRG-MIX1,2
If the throttle channel is used as the "MST" while "BOAT" is selected as
the throttle-stick mode (TH-STK) in the THR-MODE function, the rate
of the "BRK" side is not adjustable. Only "FWD" side is operative.