Futaba 3VCS - Manual (Page 96)

97
Functions
(Initial screen)
Use the or
button to select the
menu screen.
Press the button.
Use the or
button to select the
function.
Press the button.
Calling the setup screen
* When the direct call button is set,
the setup screen is also called by the
following method:
MENU SELECT
DIRECT SEL
Press the and
button simulataneously.
Press the button set
at this function.
* Calling from menu screen
(Initial screen)
MENU
HRS ECS setup/MC-SETUP
This function is used only when using an FET amp like that shown below with a high
response system (HRS System). This function is not used when using a Futaba amp.
The frame rate of the transmitter output signal at setup may be counted and the setup
mode forcefully ended after a fixed time has elapsed, depending on the commercially
available FET amp. If such an FET amp is used with the high response system, the
setup time will be substantially shortened and FET amp setup may become difficult.
When you have an FM receiver or PCM receive, only amp setup is possible in the
PPM or PCM mode.
When using this function to make adjustments, the FET amp must be directly
connected to the transmitter. Also, the following connection cords are necessary.
- Two-way cord (Must be bought separately.)
- DSC cord (Supplied with set.)
This screen does not appear except when the DSC
cord is connected or set to ON by display switch.
*A bar graph linked with throttle op-
eration is displayed
HRS MC setup/MC-SETUP