Futaba 3VCS - Manual (Page 81)

82
Functions
SW1 SW2
Function select switch/FUNC-SW
Settable functions
(SW1/SW2)
CH3 : Channel 3
TH-SPD : Throttle speed
AB.S. : A.B.S. function
D/R 2ND : 2nd dual rate
IDLE-UP1 : Idle up 1
IDLE-UP1 : Idle up 2
PRG MIX1 : Program mixing 1
PRG MIX2 : Program mixing 2
AT-STA : Start fanction / Engine cut
LAP START : Timer function start (SW2 not possible)
LAP RESET : Timer function reset (SW2 not possible)
OFF : (Not used)
This function allows selection of the function to be performed by the switches
(SW1/SW2) and setting of the direction, etc. of operation.
- The table below shows the functions that can be assigned to each push switch.
- SW1: The function of operation can be changed. (NOR/ALT)
- SW2:
Function select switch/FUNC-SW
Function name, etc.
Abbreviation used on setup screen
CH3 allocation
Although being the three-position switch, SW2 does not work as a three-position
switch in the case that CH3 function is allocated to the SW2. Suppose that CH3 is
allocated to one of the positions that are "Function Selectable". The output would
swing from the extreme upside to the extreme downside or to the opposite direction
when the switch position is moved from "No Function Select" position to another
position. The "Servo Reverse" (see page 72) and "End Point Adjuster" (see page 36)
functions can set the direction and amount of the movement respectively. However,
never allocate CH3 to two positions.
ARRANGE-3
SW2
SW2
SW2
ARRANGE-2
SW2
SW2
SW2
ARRANGE-1
SW2
SW2
SW2
No Function Select
Function Selectable
Function Selectable
Function Selectable
No Function Select
Function Selectable
Function Selectable
Function Selectable
No Function Select