Futaba 3VCS - Manual (Page 55)

56
Functions
Adjustment buttons
- Use the (+) and (-) buttons to make
adjustments.
- Press the (+) and (-) buttons simulta-
neously (approx. 1 sec) to return to
the initial screen.
Function ON/OFF
INH, ACT
"INH"
: Function OFF
"ACT" : Function ON
Brake rate
0 ~ 100
Initial value: 100
Brake mixing/BRAKE MIXING (Throttle, 3rd channel system)
Function ON/OFF
INH(OFF), ACT(ON), ACT(OFF)
Brake return amount
0 ~ 50 ~ 100
Initial value; 50
"0"
: No return
"50" : Return to the 50% position of
the brake operation amount
"100" : Return to the neutral posi
tion.
Delay amount
0 ~ 100
Initial value; 0
"0"
: A.B.S. function performed with
out any delay
"50" : A.B.S function performed after
an approximate 0.7 sec delay.
"100" : A.B.S. function performed after
an approximate 1.7 secs delay.
Brake mixing adjustment
(Preparation)
- Select setup item "MODE" and make the following
adjustments.
1 (Function ON/OFF)
Set the function to the "ACT" state by pressing
the (+) or (-) button.
2 (3rd channel brake rate)
Select setup item "RATE" by pressing the (DN)
button five times, and use the (+) and (-) buttons
to adjust the 3rd channel brake rate amount.
3 (3rd channel brake-EXP)
Select setup item "EXP" by pressing the (DN)
button. When you want to quicken the rise, use
the (+) button to adjust the + side and when you
want to make the rise milder, use the (-) button to
adjust the - side.
4 (Delay amount setup)
Select setup item "DLY" by pressing the (DN)
button once, and use the (+) and (-) button to
adjust the delay amount.
"0": No delay
"100": Maximum delay amount
- This system sets either the "F" side or "R" side delay.
5 (3rd channel brake-A.B.S ON/OFF)
Select setup item "CH3ABS" by pressing the
(DN) button once.Set the function to the "ACT"
state by pressing the (+) or (-) button.
6 (3rd channel brake-A.B.S return amount adjustment)
Select setup item "ABP" by pressing the (UP)
button 3 times and use the (+) and (-) buttons to
adjust the return amount.
7 (3rd channel brake-A.B.S delay amount setup)
Select setup item "DLY" by pressing the (DN)
button once and use the (+) and (-) buttons to
adjust the delay amount.
8 When ending adjustment, return to the initial
screen by pressing the (END) button 3 times.
3rd channel brake rate
100 ~ 0 ~ +100%
Initial value: 0
Delay amount (DLY)
F100~F1, 0 ,R1~R100
However, at least one must be "0".
Initial value: 0