Futaba 3VCS - Manual (Page 95)

96
Functions
(Initial screen)
Use the or
button to select the
menu screen.
Press the button.
Use the or
button to select the
function.
Press the button.
Calling the setup screen
* When the direct call button is set,
the setup screen is also called by the
following method:
MENU SELECT
DIRECT SEL
Press the and
button simulataneously.
Press the button set
at this function.
* Calling from menu screen
(Initial screen)
MENU
Ending the setup screen
1 When ending servo operation checks, return to
the initial screen by pressing the (END) button 3
times.
Servo view/SERVO
Servo operation of each channel can be checked. Operation at steering angle
adjustment, when a mixing function was set, etc. can be easily checked. The servo
view can also be displayed on the initial screen by using the system function (See
page 92).
The neutral position of the throttle channel varies depending on the modes defined by
the "THR-MODE". The screen shown below shows an example of "F50/B50" in the
"NORMAL" mode.
100% position 100% position
* Steering operation
* Throttle operation
* Channel 3 operation
Servo view/SERVO
Neutral position of the throttle