Futaba 3VCS - Manual (Page 36)

37
Functions
(Initial screen)
Use the or
button to select the
menu screen.
Press the button.
Use the or
button to select the
function.
Press the button.
Calling the setup screen
* When the direct call button is set,
the setup screen is also called by the
following method:
MENU SELECT
DIRECT SEL
Press the and
button simulataneously.
Press the button set
at this function.
* Calling from menu screen
(Initial screen)
MENU
Steering EXP/ST-EXP (Steering system)
This function is used to change the sensitivity of the steering servo around the neutral
position. It has no effect on the maximum servo travel.
Racers Tip
When the setting is not determined, or the characteristics of
the model are unknown, start with 0%. (When EXP is set to
0%, servo movement is linear.)
Setup item
RATE: Steering EXP rate
Vertical cursor moves in step with
steering wheel operation.
Adjustment range
-100~0~+100%
Steering EXP/ST-EXP (Steering system)
Adjustment buttons
- Use the (+) or (-) buttons to make ad-
justments.
- Return to the initial value by pressing
the (+) and (-) buttons simultaneously
(approx. 1 sec).
-1% ~ -100%
(mild)
Steering wheel
travel
Steering wheel
travel
(Quick)
Servo travel
(Mild)
Servo travel
0%
(normal)
0%
(normal)
+1% ~ +100%
(quick)
Dial / Trim Setting
The steering EXP adujustment (RATE) can be con-
trolled with button trim BT1, BT2 or digital trim DT3
etc. with the function select dial function. (See page 80 )
Steering EXP adjustment
1 When you want to quicken steering operation,
use the (+) button to adjust the + side. When you
want to make steering operation milder, use the
(-) button to adjust the - side.
2 When ending adjustment, return to the initial
screen by pressing the (END) button 3 times.