Futaba 3VCS - Manual (Page 67)

68
Functions
When Steering and Throttle Travel is Insufficient
When the steering servo travel is insufficient even when D/R is 100% and EPA is
120%, programmable mixing can be used to increase the travel somewhat.
(Reference data)
- PROG NIX1->ON
- MST (master channel) -> ST Mixing is applied from steering
- SLV (slave channel) ->ST Mixing is applied to steering and the travel is increased.
- RGH -> 10% [When subtrim is centered (0%)]
- LFT -> 10% [When subtrim is centered (0%)]
- TRM -> OFF
- OFS -> 0%
- MXMD -> MIX
However, the operating range of the servo is exceeded
even if a large value is input at RIGH and LEFT and a
zone over which the servo does not operate even when
the stick is moved to the left or right is created. A zone
over which the servo does not operate is also generated
at the moving side when the subtrim is moved to the
left and right. Therefore, set the RIGH and LEFT value
by checking servo operation.
When the throttle servo travel is insufficient at ATL 100% and EPA120%, the same
action can be performed by making TH (throttle) both the MST and SLV when steer-
ing.
When both steering and throttle operations are performed, use both PROG MIX1 and
PROG MIX2 program mixing.
Zone over which servo
does not operate
Full left Full right
Program Mixing 1,2/PRG-MIX1,2
7 (Trim mode setup)
Select setup item "TRM" by pressing the (DN)
button once, and use the (+) or (-) button to se-
lect the mixing mode.
"OFF" : Trim is added.
"ON"
: Trim is removed.
9 When ending adjustment, return to the initial
screen by pressing the (END) button 3 times.
Trim mode
OFF, ON
Initial value: OFF