Futaba 3VCS - Manual (Page 87)

88
Functions
(Initial screen)
Use the or
button to select the
menu screen.
Press the button.
Use the or
button to select the
function.
Press the button.
Calling the setup screen
* When the direct call button is set,
the setup screen is also called by the
following method:
MENU SELECT
DIRECT SEL
Press the and
button simulataneously.
Press the button set
at this function.
* Calling from menu screen
(Initial screen)
MENU
HRS/PCM/PPM mode selection
1 (Mode selection)
Use the (DN) or (UP) button to select the mode.
- Selected by moving the box cursor.
2 (Writing to memory)
Press the (+) and (-) buttons simultaneously for 1
second.
- The "MEMORY" display is switched.
3. When ending adjustment, return to the initial
screen by pressing the (END) button 3 times.
The signal is output in the new mode when the
transmitter power is turned on again.
HRS/PCM/PPM select/MOD-MODE
The signal mode output from the transmitter can be changed. (PPM/PCM/HRS)
Receiver
When using an FM receiver set to the PPM side, when using a PCM receiver, set to
the PCM side and when using an HRS receiver, set to the HRS side.
- When the mode was changed and when a model of a different mode was
selected, signals are output in the mode set at the point at which the
transmitter power was turned back on.
* At mode selection, the box cursor
moves.
* Mode currently set in memory.
* Mode currently operating.
Modes
PPM, PCM, HRS
HRS/PCM/PPM select/MOD-MODE