Futaba 3VCS - Manual (Page 89)

90
Functions
(Initial screen)
Use the or
button to select the
menu screen.
Press the button.
Use the or
button to select the
function.
Press the button.
Calling the setup screen
* When the direct call button is set,
the setup screen is also called by the
following method:
MENU SELECT
DIRECT SEL
Press the and
button simulataneously.
Press the button set
at this function.
* Calling from menu screen
Use the or button to
select the setup item.
* blinks at the current
setup item.
(Initial screen)
MENU
Steering
Throttle
Adjuster/ADJUSTER
Steering stick and throttle stick correction can be applied. Use this function when a
mechanical offset has occurred for some reason.
However, when correction was executed, it may be necessary to recheck
the set values of all the setup functions.
Adjuster/ADJUSTER
Steering adjustment
(Preparation)
- In the steering side selected state, select the adjustment screen
by pressing the (SEL) button.
1 (Steering neutral adjustment)
In the neutral setup screen (figure at the right) state,
lightly pull the steering stick and then press the (SEL)
button in the state in which the stick is not being touched.
2 (Steering throw adjustment)
In the throw setup screen (figure at the right) state, lightly
turn the stick fully to the left and right and press the (SEL)
button.
3 (Correction execution)
At the check screen (figure at the right), check if neutral
is near "0%) and that the left and right throws are near
"130%" and press the (+) and (-) buttons simultaneously.
Internal checks are performed automatically and when
each adjustment point is in a fixed range, correction is
performed and "SUCCESSFUL!" (figure at the right) is
displayed.
If an adjustment point is not within a fixed range, an error