Futaba 3VCS - Manual (Page 19)

20
Before Using
Charging the Ni-cad Battery
Charging
1. Plug the transmitter cord of the
special charger into the charg-
ing jack on the rear of the trans-
mitter.
2. Plug the charger into an AC out-
let.
3. Check that the charging LED
lights.
Charger
Transmitter charging
LED
Cord to transmitter
charging jack
AC outlet
Caution
Pay full attention so that the battery cover wouldn't pinch the cable of the Ni-cad
battery.
Pinching the cable by the battery cover can lead to an electrical shortage, fire and abnormal heat generation,
which may cause burns and fire disaster.
Ni-cad Battery Replacement
The Ni-cad battery is connected by a connector so that it can be removed when you
will not be using the transmitter for a long time, or when replacing a dead battery with
a spare battery.
- Always use an NT8F7000B Ni-cad battery.
Ni-cad battery
NT8F700B
PHONE
Removal
- While pressing here
Battery cover
1. Slide the transmitter battery cover
in the arrow direction while press-
ing the part shown in the figure.
2. Remove the Ni-cad battery and dis-
connect the connector.
Mandatory Procedures