CIRCUTOR CIRLAMP Series - Manual (Page 10)

4�- CirLAMP Manager
4.1.- INSTALLATION OF THE UNIT
4�1�1� PRELIMINARY RECOMMENDATIONS
In order to use the unit safely, it is critical that individuals who handle it follow
the safety measures set out in the standards of the country where it is being
used, use the necessary personal protective equipment, and pay attention to
the various warnings indicated in this instruction manual.
The CirLAMP Manager unit must be installed by authorised and qualified staff.
The power supply plug must be disconnected before handling, altering the connections or
replacing the unit. It is dangerous to handle the unit while it is powered.
Also, it is critical to keep the cables in perfect condition in order to avoid accidents, personal
injury and damage to installations.
The manufacturer of the unit is not responsible for any damage resulting from failure by the
user or installer to observe the warnings and/or recommendations set out in this manual, nor
for damage resulting from the use of non-original products or accessories or those made by
other manufacturers.
If an anomaly or malfunction is detected in the unit, do not use it to perform any operation.
The unit must be disconnected from any power supply before carrying out any
maintenance or repairs, or handling any of the unit's connections.
Please contact the after-sales service if you suspect that there is an operational
fault in the unit.
4�1�2� INSTALLATION
The CirLAMP Manager unit must be installed on an electric panel or enclosure, attached to a
DIN rail (IEC 60715).
Two DIN rail brackets are supplied with the unit and must be installed on the unit before insta-
lling it on the electric panel.
To do so, follow these steps:
10
CirLAMP system
Instruction Manual