CIRCUTOR CIRLAMP Series - Manual (Page 59)

4.6.10.3. NTP configuration
Figure 61:NTP configuration.
On this screen you can configure the following configuration parameters for the NTP:
 ipNtp: IP address for NTP synchronisation.
 ntpMaxDeviation: Time deviation to create an event, in seconds.
4.6.10.4. FTP configuration
Figure 62:FTP configuration.
On this screen you can set up the following configuration parameters for the FTP:
 ipFtp: IP address for the server to which the reports will be sent.
 ftpUser: Username for the server to which the reports will be sent.
 ftpPwd: Password for the server to which the reports will be sent.
 pathReports: Server path to where the reports are sent.
 retryFtp: Number of retries for accessing the FTP server.
 timeBetwFtp: Time between retries for accessing the FTP server, in seconds.
 FtpServer: FTP server.
 FtpsServer: FTP server on TLS.
4.6.10.5. Mail configuration
The unit can send a report via email when a node alarm is activated.
Figure 63:Mail configuration.
59 Instruction Manual
CirLAMP system