Baby Lock ProStitcher Version 14.04.0051 (BLPS2) Instruction and Reference Guide - Manual (Page 11)

Pro-Stitcher User Manual 3.6 Installation Instructions
Figure 3.7
Y-Rack Installation
1. Carefully lay the quilting machine on its power
pod side (the left side, looking from the front).
Underneath the base plates, near the wheels on
the C-Pod side of the machine (the side with the
thread tensioner and guides) there will be either
two screws or two holes. If the screws are there,
use a large slotted (flat) screwdriver to remove the
screws (see Figure 3.7).
2. Attach the Y-Rack as shown in Figure 3.8. The
blue flexirack should be toward the middle of the
machine while the bolt holes should be toward
the outside. Use the screws that were removed
from the front and rear base plates (or use the two
smallest screws in the Base Plate Repair Kit (Page
3.3 D) if your machine had no screws here) to
mount the Y-Rack to the bottom of the front and
rear base plates. Be careful not to over-tighten the
screws as the base plate holes will strip easily. In
case of accidentally cross-threading or stripping
one of the base plate holes, an emergency repair
kit (Page 3.3 D) has been provided.
3. If the screws in the base plates do not have slotted
heads and a nut driver cannot be fitted over the
screw head, please use one of the provided slotted
screws as a replacement (Page 3.3 D) and use a
slotted screwdriver to tighten the screws in place.
Figure 3.8
Y-Rack
Y-Encoder