Baby Lock ProStitcher Version 14.04.0051 (BLPS2) Instruction and Reference Guide - Manual (Page 48)

Design Menu 5.21
Freehand
The Pro-Stitcher can record the movement of the
quilting machine using the functions available in the
Freehand panel. Because the Pro-Stitcher is reading
the motion of the carriage motors, the Freehand
function requires that the carriage levers be in the
engaged (down) position. If the motors are enabled
(i.e. the quilting machine is locked in position), press
the Disable Motors button at the top right-hand
corner of the screen.
Select the Design menu and then press the
Freehand sub-menu button to reveal the Freehand
panel, which includes four functions (Figure 5.71).
Clear
Press the Clear button to clear any designs from the
Work Area (Figure 5.72). This also clears anything
that has been recorded with the Record button.
When adding to an existing design using Freehand
rather than clearing the screen, the Pro-Stitcher will
first Baseline the design to treat the current state of
the design as a single design.
Record
Press the Record button to start recording the
motion of the quilting machine (Figure 5.73). If a
design was left on the Work Area, a stitch line will
be placed between the end point of the current
design and where the crosshairs are when the
Record button is pressed. This enables a quilter to
add additional stitching to the end of the design
if desired. For those quilters who are accustomed
to free-motion long-arm quilting, there will be
some added drag due to the carriage motors being
engaged and it may take some practice to get
accustomed to this feel.
Figure 5.71
Figure 5.72
Figure 5.73