Leprecon Litescape dimmer - Manual (Page 26)

Litescape User’s Manual, Page 10
2 Press ENTER.
3 The month will be blinking in the display. If the month needs to be changed, use up and down arrow
keys to change the month until the correct month is displayed. Press
ENTER to save the change.
4 If the day needs to be changed, press the right arrow key once so that the day field is blinking. Use
the up and down arrow keys to change the displayed day to the correct day. Press
ENTER to save
the change.
5 Continue as in steps 4 and 5 to adjust the year, hour, minutes or seconds as needed by using the
right arrow to move to the next field, and the up/down arrow keys to change the number displayed in
the field. Press
ENTER after each field is updated to save the change.
6 The AM/PM portion of the time cannot be updated as a separate field but must be changed by cycling
through the hours past 12.
7 To exit, press the left arrow key until MAIN MENU is showing in the display.
How to Reboot the System
1 The easiest way to reboot the Houselite system is to turn off the main power breakers supplying each
of the LWD-2400 dimmers in the system.
It is wise to turn off the 12 channel breakers on each dimmer before powering off the system so that
lights do not come on suddenly when the system is powered back up.
2 An alternate but less convenient method of powering off the system is to interrupt power to the
processor board. To do this, open the panel door of each LWD-2400 dimmer in the system, locate
the red rectangular power plug on the processor board and unplug it. Then replace each power plug.