Leprecon Litescape dimmer - Manual (Page 78)

Litescape User’s Manual, Page 62
The programming mode for ZONE’s channel levels (see next menu) can be set to view, edit, or
snapshot. In view mode, the currently programmed levels are shown, but cannot be changed. In edit
mode, the current levels are shown and can be changed using the UP and DOWN keys. In snapshot
mode, the input DMX levels are transferred and displayed in the ZONE’s channel position. They are
programmed into ZONE when the ENTER key is pressed.
To get to this menu, press NEXT from the above menu. Select the CHANnel to view or edit by pressing
NEXT and PREV (see PROGRAM MODE menu above). If in edit mode, change the currently highlighted
channel’s LEVel by pressing the UP and DOWN keys. Changes are instantaneous, it is not necessary to
press ENTER. If in snapshot mode, set the desired look using the attached console, then press ENTER
to capture all dimmer channels from the input DMX stream (not just the currently selected channel).
Select Preset, Edit Preset Name, Edit Preset Program Mode, Edit Preset Output Levels
Upon initialization, PRESETS are given default names and ZONE output levels. These menus are used
to modify the names and levels for the particular installation.
To get to this menu, press NEXT while in the SELECT ZONE menu. Press UP or DOWN to select the
PRESET name to modify, then press ENTER to begin editing the name.
Select the character to edit by pressing NEXT and PREV. Change the currently highlighted character by
pressing the UP and DOWN keys. Changes are instantaneous; it is not necessary to press ENTER. Press
NEXT to edit the ZONE LEVELS associated with this PRESET.
The programming mode for the PRESET’s zone levels can be set to view, edit, or snapshot. In view
mode, the currently programmed levels are shown, but cannot be changed. In edit mode, the current
levels are shown and can be changed using the UP and DOWN keys. In snapshot mode, the input DMX
levels are treated as if they were Wall Panel ZONE faders. The corresponding ZONE level follows the
DMX console. The PRESET is programmed when the ENTER key is pressed.
To get to this menu, press NEXT from the above menu. Select the ZONE to view or edit by pressing
NEXT and PREV (see PROGRAM MODE menu above). If in edit mode, change the currently highlighted
zone’s Level by pressing the UP and DOWN keys. Changes are instantaneous; it is not necessary to
press ENTER. If in snapshot mode, set the desired ZONE look using the attached console, then press
ENTER to capture all 12 ZONE levels from the input DMX stream (not just the currently selected ZONE).