Hakko MONITOUCH V7 series - Manual (Page 170)

4
1. Ethernet 4-19
Netw
or
k C
o
mm
uni
ca
tio
n
s
V-SFT Setting (Macro)
This section explains the macro commands (SEND/EREAD/EWRITE) used for the
Ethernet. For more information on macro commands, refer to the Reference Manual
(Function).
Macro Command
[EREAD]
Words from the F1 memory in the V7 series of the network table number specified for
F3 are read into the F0 memory. F2 designates the number of words to be read.
Usable Devices
EREAD: Read into memory
EREAD F0 = F1 C: F2 F3
Example: Macro command at the V7 (A)
The macro command for V7 (A) to read data from PLC (B) and transfer it to
PLC (A) is shown below.
[Contents] Two words starting from D100 in PLC (B) are read into D200 in PLC
(A).
Internal
Memory
PLC
Memory
Constant
Memory
Card
Indirect
Designation
Double
-word
IP Address
F0
F1
F2
F3
[Description] EREAD D200 = D100 C: 2 B
Top memory address
of the target
Top memory address
of the source
The number of words
to be transferred
Address of the source
(Network table number)
run
<PLC: A>
Ethernet
<V7: A>
<PLC: B>
<V7: B>
D200 - 201 D100 - 101
PROGRAMMER
F A C T O R Y A C E
F1
F2
F3
F4
F5
F6
F7
SYSTEM
POWER
F1
F2
F3
F4
F5
F6
F7
SYSTEM
POWER
EREAD
<V7 (A)>
<PLC (A)>
<V7 (B)>
<PLC (B)>