Hakko MONITOUCH V7 series - Manual (Page 165)

4-14 1. Ethernet
V-SFT Setting (Network Table Editing)
To enable Ethernet communications on the V7 series, the following network table setting is
required on the V-SFT editor.
Network Table
• The V7 series, PLCs and PCs on the Ethernet must be registered on the network table.
In the case of the network illustrated below, the nodes with (
∗) should be registered on
the network table.
• The network table is transferred to the V7 series together with screen data.
When [Use Ethernet] is selected in the [Comm. Parameter] dialog, be sure to edit the
network table.
RS-232C
RS-485
V-SFT
F1
F2
F3
F4
F5
F6
F7
SYSTEM
POWER
F1
F2
F3
F4
F5
F6
F7
SYSTEM
POWER
Ethernet
Ethernet-ready PLC
Server
Application
<PC>
V-SFT
<V7>
F1
F2
F3
F4
F5
F6
F7
SYSTEM
POWER
Server
Transfer
Screen data
I/F driver
Network table