Hakko MONITOUCH V7 series - Manual (Page 43)

1-26 10. DIP Switch Setting
10. DIP Switch Setting
DIP Switch (DIPSW) Setting
Set the terminating resistance for RS-422/485 connection with the DIP switch. When
setting the DIP switch, turn the power off.
- For V708/V708i: - For V710/V710i/V712/V712i:
* Set DIPSW2 to 5 (not used) to the OFF position.
Terminating Resistance Setting (DIPSW6, 7, 8)
• When connecting the PLC at CN1 via RS-422/485 interface, set DIPSW7 to the ON
position.
• For the following connections at modular jack 1 (2), set DIPSW 6 (DIPSW8) to the ON
position.
- Master station for multi-link 2 connection
- Temperature controller network/PLC2Way connection via RS-485
- Connection with the card recorder CREC (optional)
- Connection with the serial extension I/O V-I/O (optional)
- Connection to the V7 unit at the termination of V-link connection via RS-485
100-240VAC
L N LAN CN1 MJ1 MJ2 PRINTER
CF
CN5
MEMORY
CN6
Side View Rear View
DIP switch
ON
1 2 3 4 5 6 7 8
CF auto load
MJ2 (modular jack 2) terminating resistance
CN1 RD terminating resistance at pins 24 and 25
MJ1 (modular jack 1) terminating resistance
Not used