Hakko MONITOUCH V7 series - Manual (Page 119)

3-22 6. V-Link
Wiring
Cable
Use Hakko Electronics’ cable “V6-TMP” (3 m) for connection with a computer. The
shielded frame ground of V6-TMP must be connected to the V7 series.
* Notes on Use of V6-TMP
There are six wires in the V6-TMP cable as shown on
the right. The wires to be used are determined
depending on the connecting method. For the wires
not used, be sure to properly insulate with tape, etc.
RS-232C (V7 series: 1 set)
Wiring example of above (a)
: 0V SG
: RXD
: TXD
: +5V
: +SD/RD
: -SD/RD
V6-TMP
Brown
Red
Orange
Yellow
Black
Green
CN1
MJ2/1
a V6-TMP
RS-232C
RS-422
RS-485
PLC
RS-232C
Computer
V7
Local
Port 1
TXD 8 RD
SD
SG
CS
2
3
5
6
RXD
SG
7
5
RS 7
8
DR
FG
Signal Name
Computer
D-sub 9-pin (female)
Pin No.
(Yellow)
(Orange)
(Red)
V7 series
Modular jack, 8-pin
Pin No.
Signal
Name