Hakko MONITOUCH V7 series - Manual (Page 198)

4
1. Ethernet 4-47
Netw
or
k C
o
mm
uni
ca
tio
n
s
Errors during Macro Command Execution
The execution result of macro commands SEND/EREAD/EWRITE is stored in system
memory address $s515.
• System memory address: $s515 (response to the request)
Code Contents Solution
0 Normal
200 - 2000 Communication error Refer to “Communication Errors.”
−30
Timeout Check if an error is occurring to the target V7.
−31
The number of words being sent exceeds
the limit. Check the number of words that can be sent in macro
editing.
−32
Specified table not used Check the setting on the network table.
−33
Cannot use the send command. Check the macro command in macro editing.
−34
Specified table being used Check that system memory address $s514 is set. If
not, reduce the frequency of communications.
−35
Cannot process due to short memory Check the memory space at the target station.
−36
Illegal receive packet bytes Check the requested number of words.
−37
Memory access error Check the setting of the requested memory.
−38
Macro setting error Check the macro setting.