Emerson Process Management OXYMITTER 4000 IM-106-340 - Manual (Page 136)

Oxymitter 4000
9-20
Instruction Manual
IM-106-340, Rev. 4.0
May 2006
Figure 9-12. Contact and
Thermocouple Assembly
Replacement
Termination Housing Wiring (Remote Electronics Probe Head Only)
Under normal circumstances, the right termination housing cover should not
need to be removed. This side of the housing contains the probe signal wire
connector and the probe heater wire connector that plug into the adapter
board. If these wires should become disconnected or need to be replaced,
use the diagram in Figure 9-12 to reconnect the wires.
36940005
J4
J7
J2
J5 J6
J3
Probe Signal
Wire Connector
Probe Heater
Wire Connector
4 Wire
2 Wire