Emerson Process Management OXYMITTER 4000 IM-106-340 - Manual (Page 39)

Instruction Manual
IM-106-340, Rev. 4.0
May 2006
Oxymitter 4000
http://www.processanalytic.com
Section 2 Installation
Mechanical Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . page 2-2
Electrical Installation (with Integral Electronics) . . . . . . . page 2-10
Electrical Installation (with Remote Electronics) . . . . . . . page 2-13
Pneumatic Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 2-16
IMPS 4000 Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . page 2-18
SPS 4001B Connections . . . . . . . . . . . . . . . . . . . . . . . . . . page 2-18
Before installing this equipment, read the "Safety instructions for the wiring and installation
of this apparatus" at the front of this Instruction Manual. Failure to follow safety instructions
could result in serious injury or death.
Install all protective equipment covers and safety ground leads after installation. Failure to
install covers and ground leads could result in serious injury or death.
The Oxymitter 4000 (OXT4A) can be installed in general purpose areas only. Do not install
the OXT4A in hazardous areas. For hazardous areas use the OXT4C.