H3C Technologies H3C S5560 Series Switches - Manual (Page 326)

310
PrefVal : 0 OutLabel : NULL
MED : 0
Path/Ogn: 100i
* >i Network : 100:: PrefixLen : 96
NextHop : 101::2 LocPrf : 100
PrefVal : 0 OutLabel : NULL
MED : 0
Path/Ogn: i
* >i Network : 101:: PrefixLen : 96
NextHop : 102::1 LocPrf : 100
PrefVal : 0 OutLabel : NULL
MED : 0
Path/Ogn: i
* > Network : 102:: PrefixLen : 96
NextHop : :: LocPrf :
PrefVal : 32768 OutLabel : NULL
MED : 0
Path/Ogn: i
* i Network : 102:: PrefixLen : 96
NextHop : 102::1 LocPrf : 100
PrefVal : 0 OutLabel : NULL
MED : 0
Path/Ogn: i
The output shows that Switch D has learned the network 1::/64 from Switch C through route reflection.
6PE configuration example
Network requirements
As shown in Figure 76 , use 6PE to connect two isolated IPv6 networks over an IPv4/MPLS network.
• The ISP uses OSPF as the IGP.
• PE 1 and PE 2 are edge devices of the ISP, and establish an IPv4 IBGP connection between them.
• CE 1 and CE 2 are edge devices of the IPv6 networks, and they connect the IPv6 networks to the
ISP.
• A CE and a PE exchange IPv6 packets through IPv6 static routing.