H3C Technologies H3C S5560 Series Switches - Manual (Page 53)

37
• If the specified neighbor is not directly connected, disable source address check on incoming
updates.
To specify a RIP neighbor:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Specify a RIP neighbor. peer ip-address
By default, RIP does not
unicast updates to any
peer.
4. Disable source IP
address check on
inbound RIP updates undo validate-source-address
By default, source IP
address check on inbound
RIP updates is enabled.
Configuring RIP network management
You can use network management software to manage the RIP process to which MIB is bound.
To configure RIP network management:
Step Command Remarks
1. Enter system view. system-view N/A
2. Bind MIB to a RIP
process.
rip mib-binding process-id
By default, MIB is bound to the RIP
process with the smallest process
ID.
Configuring the RIP packet sending rate
Perform this task to specify the interval for sending RIP packets and the maximum number of RIP packets
that can be sent at each interval. This feature can avoid excessive RIP packets from affecting system
performance and consuming too much bandwidth.
To configure the RIP packet sending rate:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Specify the interval for
sending RIP packets and the
maximum number of RIP
packets that can be sent at
each interval.
output-delay time count count
By default, an interface sends up to
three RIP packets every 20
milliseconds.