Grass Valley PVS Series System Guide v.4.0 Dec 10 200 - Manual (Page 185)

Deleting unwanted VITC signals
July 27, 2001 Profile XP System Guide 185
Deleting unwanted VITC signals
You can remove unwanted VITC signals that may be present in a recorded video clip
or on the output during E to E by selecting which VBI lines to erase. You can erase
VBI lines by selecting the range of line numbers between line 1 to line 32. Blanking
level is inserted in place of the VBI information. Lines are erased before VITC
timecode is inserted.
To erase VITC lines:
1. Choose Video Output in the Configuration Manager Window. The Video Output
dialog box appears.
2. Click Next to navigate to Video Output page 2 of 3.
3. Select a video output from the list or click Select All to configure all the video
outputs at the same time.