Grass Valley PVS Series System Guide v.4.0 Dec 10 200 - Manual (Page 68)

Chapter 3 Working with Profile XP storage systems
68 Profile XP System Guide July 27, 2001
9. Connect Profile XP system power cord as shown, and turn on the front panel
standby switch.
10. Wait for Windows NT to initialize and perform auto-logon. The Windows NT
desktop will appear after successful auto-logon.
During initialization, the Profile XP system software checks the PFC500 storage
system for a valid video file system. If one is not found, a warning message is
displayed. A valid file system is required for Profile Applications to start.
11.Do one of the following:
a. If this is the first time power-up of the system, you must configure the storage
system. Proceed by following the procedures in “Configuring storage using
Disk Utility” on page 69.
b. If you know you have a valid file system, and one is not found, first make sure
all PFC chassis are connected, powered-up, and fully initialized. If this does not
help, refer to the Profile XP Service Manual and the PFC500 Instruction
Manual for help in isolating the problem.
NOTE: Always make sure all chassis in the PFC500 storage system are powered-on
and fully initialized (2-3 minutes) before powering on the Profile XP system or
restarting Windows NT. Failure to do so will prevent the Profile XP system from
having access the media files stored on the PFC500 storage system.
0624-47
Profile XP Media Platform
Power
Cord(s)
(115V/230V)
Option RD only
Standard
Power Supply
Optional
Power Supply