iSys iTerra Elite Color LED Printer User Manual
Page 25
_________________________________________________________________________________________________________________________
PAGE 25 --- iTerra Elite Quick Start Guide
© 2008 iSys-The Imaging Systems Group Inc.
III.
NETWORK INSTALLATION
C. Network Port Connection
1)
Turn the printer off.
2)
Connect your Ethernet cable to the network port on the printer (1).
3)
Connect the other end of the Ethernet cable to the network port, Hub or host system (2).
4)
Turn the printer on and wait for the print server status light (3) to stop blinking.
If you are unaware of what the network IP set value is for the printer, follow the instructions below to determine that value.
You will need to know the printer IP before you can load the printer driver.
If a network configuration card is not already installed refer to Trouble Shooting Chapter and/or Accessory installation (if
network card is purchased later than printer).
NOTE:
Ethernet® cable is not supplied with the printer. Use an Ethernet cable with two twisted wire pairs and an
RJ45 plug.