iSys iTerra Elite Color LED Printer - Manual (Page 26)

_________________________________________________________________________________________________________________________
PAGE 26 --- iTerra Elite Quick Start Guide
© 2008 iSys-The Imaging Systems Group Inc.
IV. PRINT DRIVER INSTALLATION
Overview Windows 2000 & Windows XP
The iTerra Elite (CLP825) Continuous Printer Driver for Windows 2000 & XP allows users to print directly from Windows
applications to the iTerra Elite printer. These instructions describe installation of drivers from a driver installation CD ROM
or from driver files on your hard disk to the Windows 2000 host system.
Printing can be done through the parallel port, USB port or a network. The printer can be set up as a shared device so
that other Windows host systems on the network can access it although drivers will need to be loaded on each of the host
systems.
Preparation
The following items will be necessary to complete this installation procedure:
1) Be sure that the IP address of the printer has been properly assigned and set. The IP address of the printer is
required in the driver installation. See the next section entitled ‘Network Card IP Address checking and setting’ to
check, change and set the printer’s IP.
2) Ensure that the driver can be accessed on the host system. You may have a CD ROM that was supplied with the
purchase of the printer or you may have downloaded a driver zip file from the www.isys-group.com website. If
you did download a zip file you will have to unpack the files and make note of the location to where you have
unpacked it.
3) It is a good idea to have the Windows 2000 distribution CD available at the time of the driver installation.