Cobalt Co9992-4ENC-4K-HEVC Software-Defined Broadcast Encoder - Manual (Page 13)

13
Indicators and Switches
The 9992-ENC card and its rear module are intended for installation only in 20-slot openGear ®
frames such as the 20-slot OG3-FR frame or the Cobalt HPF-9000 frame. Prior to installing the
card, first install the corresponding rear panel I/O module.
Rear I/O Panel Indicators
The 9992-ENC rear I/O panel is depicted below. It includes the following:

8 HD-BNC connectors, organized as follows:
o Connectors 1 and 2 support SD-SDI, HD-SDI, 3G-SDI, 6G-SDI and 12G-SDI
signals. They correspond to Video 1 and Video 2 inputs in the GUI.
o Connectors 6 and 8 support SD-SDI, HD-SDI and 3G-SDI signals. They
correspond to Video 3 and Video 4 inputs in the GUI.
o The remaining connectors are unused.

2 ASI output ports on standard BNC connectors.

Two 10/100/1000 Mb/s Ethernet ports on standard RJ-45 connectors.

A GPIO block (currently unused)
Each of the video inputs has a green indicator LED, with the following states:

LED off: no video signal detected, or input not configured.

LED ON: video input locked to the video signal.
Each of the ASI output ports has a green indicator LED, with the following states:

LED off: ASI output port is disabled.

LED ON: ASI output port is configured and enabled.
Each of the Gigabit Ethernet ports has two indicator LEDs, with the following states:

Green LED:
o Off: No link
o On: Link

Yellow LED:
o Off: No activity (transmit and/or receive)
o On: Port is currently transmitting and/or receiving