Cobalt Co9992-4ENC-4K-HEVC Software-Defined Broadcast Encoder User Manual
Page 64
64
RTMP Protocol:
Select the protocol variant, as discussed above.
Primary Server:
Enter the host name or IP address of the primary (or single) RTMP
server to be contacted. If you want to use host names instead of IP addresses, make sure
to configure at least one DNS server. DNS servers may be configured in the Network
Configuration DNS Tab.
Primary Network Interface:
Select the network interface to be used when contacting
the primary server. The settings are:
o
Any:
use the “best” network interface to connect to the server.
o
Ethernet 1:
preferably use Ethernet 1 to connect to the server. If the server is not
in the same subnet as Ethernet 1, and no default gateway is set for Ethernet 1, this
setting will be ignored.
o
Ethernet 2:
preferably use Ethernet 2 to connect to the server. If the server is not
in the same subnet as Ethernet 2, and no default gateway is set for Ethernet 2, this
setting will be ignored.
Primary App:
Enter the application name in the primary server, as discussed above.
Consult your CDN or server documentation to find out what should be entered in this
field.