Front indicators – Cobalt Co9992-4ENC-4K-HEVC Software-Defined Broadcast Encoder User Manual
Page 14
14
Front Indicators
A similar set of indicators exist in the front of the board. These are visible when the frame front
door is opened. The indicator layout is depicted below.
The LED indicators are as follows:
PWR LED:
indicates that the power received from the frame is OK.
o
Green:
power OK
o
Off:
no power (or insufficient voltage – check the frame power status)
Status LED:
indicates the overall status of the board.
o
STAT1:
is Green
no active alarm
o
STAT2:
is Red at least one critical alarm present
REF and DMOD:
are unused at this time.
SDI 1, SDI 2, SDI 3, and SDI 4 LEDs:
these behave the same as the corresponding rear
I/O panel indicators.
AS1 1 and ASI 2 LEDs:
these behave the same as the corresponding rear I/O panel
indicators.
ETH1 and ETH2 LEDs:
these indicate the status of the corresponding Ethernet
connection.
o
Off:
no link
o
On:
link OK, port is transmitting and/or receiving packets