Cobalt Co9992-4ENC-4K-HEVC Software-Defined Broadcast Encoder - Manual (Page 29)

29
Dashboard™ Card State will be yellow if there are no higher-priority alarms
present.
o No Link: The port does not currently have link. If Alarm on Link Loss is set to
Yes, the Dashboard™ Card State will be red and the Status LED in the front of the
board will also be red. If Alarm on Link Loss is set to No, this indicator will still be
red, but the alarm will not propagate.

Port 1/2 Status: This indicator is the port overrun status. It has the following states:
o OK : The port is operating normally.
o TX Overflow: In the current configuration, the IP outputs are attempting to
transmit more than the port capacity (i.e., the overall output data for this port
exceeds the interface speed of 100 Mb/s or 1 Gb/s). The Dashboard™ Card State
will be red and the Status LED in the front of the board will be red. In this case,
reduce the output bit rate (either by reducing the encoder bit rates or by removing
output ports).
If this indicator is red, data is being dropped .

Link Speed (Mb/s): This parameter reports the actual speed negotiated with the switch
for the port. If the port has no link, the value reported here is zero.

MAC Address: This reports the MAC address of the Ethernet port.
Network Statistics DNS Tab
The Network Statistics DNS Tab reports the current DNS configuration, including the priority
order.
If any of the ports are set for DHCP, the DNS received from the DHCP server (if any) is
displayed here. In the figure above, Ethernet 2 is set for DHCP and has received a DNS address
through that process.
Network Statistics RIST Tunnels Tab
This tab shows the current configuration of the RIST tunnels. Only the enabled parameters are
displayed.