Cobalt Co9992-4ENC-4K-HEVC Software-Defined Broadcast Encoder - Manual (Page 75)

75

Enable SDT and all the SDT parameters in Advanced Tab – Mux Parameters.

Any connections made in the Output Tab–ASI/IP Streaming.
Encoder Statistics Tab
The Encoder Statistics Tab is divided into six lower tabs, as indicated below:
The Encoder Audio Statistics Tab is divided into two lower tabs, as indicated below:
The Basic , Advanced and Output tabs in the Encoder Statistics, as well as the Basic and
Advanced tabs in the Encoder Audio Statistics, are direct equivalents of their configuration
counterparts. They present the current value of each of the configuration parameters. When the
Apply/Cancel buttons are grayed out, the contents of these tabs exactly match their
configuration counterparts. When the Apply/Cancel buttons are active, configuration
parameters have been changed. The current (running) encoder configuration can still be
inspected in the statistics tabs, prior to clicking on the
Apply button.
Encoder Statistics Status Tab
The Status Tab provides a summary of the status of the encoder. The variables displayed in this
tab vary according to the encoder configuration.
Encoder Statistics Status Tab – Common Statistics
The following basic parameters are always displayed:

Encoder Status: This gives the overall encoder status. Its values are:
o OK : The encoder is running normally.
o Stopped: The encoder has been manually stopped (see Encoder State in Basic
Tab–Encoder Configuration).
o Error: The encoder should be running but it is not. This status will be briefly
shown when the encoder is starting. The possible causes for this are:

The encoder has no input (check Encoder Video Status )