Cobalt Co9992-4ENC-4K-HEVC Software-Defined Broadcast Encoder - Manual (Page 54)

54
The following Mux Parameters are always available if the Output Protocol is not set to RTMP:

PMT PID, PCR PID, Video PID, Audio PID, SCTE 35 PID, and SMPTE 2038 PID:
These parameters control the Packet Identifier (PID) values for the PMT, PCR, Video,
and Audio, and the various ancillary data formats.
The values can be entered in
hexadecimal (prefixed by 0x) or in decimal. Valid values are from 0x20 (32) to 0x1FFE
(8190). PMT PID, Video PID and Audio PID must be distinct values. PCR PID can
either be the same as the video PID or distinct from the other values as well. The user
interface will not accept an invalid entry at any time – it will immediately revert to the
previous value. The number of audio PIDs displayed corresponds to the number of audio
channels configured in the Basic Tab–Audio Parameters. The SCTE 35 PID entry is
shown only if SCTE 104 Ad Insertion Triggers are enabled. The SMPTE-2038 PID entry
is shown only if the feature is enabled.

Program Number: Enter the desired program number for this encoder channel. Valid
program numbers go from 1 to 65535 and are always entered in decimal.

Transport Stream ID: Enter the desired Transport Stream ID for this encoder channel.
Values in this field can be entered both in hexadecimal (prefixed by 0x) or in decimal.

Generate SDT: This box is always shown but is not selectable for the HTTP Live
Streaming and RTMP protocols. If this box is checked, an SDT will be generated for this