Panasonic MN101C77C - Manual (Page 102)

Chapter 3 Interrupts
III - 8 Overview
■ Determination of Interrupt Acceptance
The following is the procedure from interrupt request input to acceptance.
(1) The interrupt request flag (xxxIR) in the corresponding external interrupt control
register(IRQnICR) or internal interrupt control register (xxxICR) is set to '1'.
(2) An interrupt request is input to the CPU, If the interrupt enable flag (xxxIE) in the same register
is '1'.
(3) The interrupt level (IL) is set for each interrupt. The interrupt level (IL) is input to the CPU.
(4) The interrupt request is accepted, if IL has higher priority than IM and MIE is '1
(5) After the interrupt is accepted, the hardware resets the interrupt request flag (xxxIR) in the
interrupt control register (xxxICR) to '0'.
Figure 3-1-4 Determination of Interrupt Acceptance
The corresponding interrupt enable flag (xxxIE) is not cleared to "0", even if the interrupt is
accepted.
7
xxxICR
VF IM1 --- IM0 NF
7 0
PSW
Level judgement. Accepted if IL<IM
Current interrupt mask level (IM)
Generated interrupt level (IL)
xxxIR xxxIE xxxLV1
CF ZF
0
MIE
xxxLV0
[ Chapter 2. 2-1-7 Processor Status Word ]
When the setting is as xxxLV=1, XXXLV0=1, the interrupt of that vector is disabled, regard-
less of the value of xxxIE, xxxIR.