Panasonic MN101C77C - Manual (Page 468)

Chapter 14 Automatic Transfer Controller
Operation XIV - 30
14-3-17 Transfer Mode C
In transfer mode C, ATC1 automatically transfers one byte of data from any memory space to any other
memory space every time an ATC1 activation request occurs.
AT1MAP0
AT1MAP0 + 1
AT1MAP0 + 2
AT1MAP0 + 3
Memory Pointer 0
00000 - 3FFFF
AT1MAP1
AT1MAP1 + 1
AT1MAP1 + 2
AT1MAP1 + 3
Memory Pointer 0
00000 - 3FFFF
(1)
(2) (2)
Set the source address in 18-bit memory pointer 0 (AT1MAP0H, M, L), and set the destination address
in 18-bit memory pointer 1 (AT1MAP1H, M, L).
In transfer mode C, the values in memory pointers 0 and 1 increment by 1 each time a byte-length data
transfer ends. As a result, the source and destination addresses for the next transfer are one address
higher than those for the original transfer.
Set the data transfer count for ATC1 in the transfer data counter (AT1TRC). The counter can be set to a
maximum of 255 transfers. The counter decrements each time ATC1 is activated. When it reaches x'00',
an interrupt (ATC1IRQ) occurs and the automatic transfer ends.
Figure 14-3-14 Transfer Mode C