Panasonic MN101C77C - Manual (Page 213)

V - 11
Chapter 5 Prescaler
Operation
5-3 Operation
5-3-1 Operation
„ Prescaler Operation (Prescaler 0 to 1)
Prescaler 0 is a 7-bit and prescaler 1 is a 3-bit free-running counter that divides the base clock. This
prescaler can be started or stopped by the PSCEN flag of the prescaler control register (PSCMD).
„ Count Timing of Prescaler Operation (Prescaler 0 and 1)
Prescaler 0 counts up at the falling edge of fosc.
Prescaler 1 counts up at the falling edge of fs.
„ Peripheral Functions with Prescaler Output Cycle Clock
Table 5-3-1 shows the prescaler output clock source that the peripheral functions can be used, and the
registers that control the clock source selection.
Table 5-3-1 Peripheral Functions Used with Prescaler Output Cycle Clock
When the prescaler output clock source is used, counting of prescaler should be enabled
before starting the peripheral functions.
Control register
External interrupt 0 Noise filter sampling clock -
External interrupt 1 Noise filter sampling clock -
Timer 0 Count clock CK0MD
Timer 1 Count clock CK1MD
Timer 4 Count clock CK4MD
Timer 5 Count clock CK5MD
Serial 0 Transfer clock SC0CKS
Serial 1 Transfer clock SC1CKS
Serial 3 Transfer clock SC3CKS
Peripheral functions