About this manual, Organization, Manual configuration – Panasonic MN101C77C User Manual

Page 4

Advertising
background image

About This Manual 1

„

„

„

„

„Organization

In this LSI manual, this LSI functions are presented in the following order : overview, basic CPU functions, interrupt

functions, port functions, timer functions, serial functions, and other peripheral hardware functions.

Each section contains overview of function, block diagram, control register, operation, and setting example.

About This Manual

„

„

„

„

„Manual Configuration

Each section of this manual consists of a title, summary, main text, key information, precautions and warnings, and

references.

The layout and definition of each section are shown below.

Sub-subtitle

The smallest block

in this manual.

Subtitle

Key information

Important information

from the text.

Main text

Precautions and

warnings

Precautions are listed

in case.

Be sure to read these

of lost functionality or

damage.

Summary

Introduction to the

section.

Chapter 2 Basic CPU

II - 44

Reset

2-8

Reset

2-8-1

Reset operation

The CPU contents are reset and registers are initialized when the NRST pin (P.27) is pulled to low.

Initiating a Reset

There are two methods to initiate a reset.

(1)

Drive the NRST pin low for at least four clock cycles.

NRST pin should be holded "low" for more than 4 clock cycles (200 nS at a 20 MHz).

Figure 2-8-1 Minimum Reset Pulse Width

(2)

Setting the P2OUT7 flag of the P2OUT register to "0" outputs low level at P27 (NRST) pin. And

transfering to reset by program (software reset) can be executed. If the internal LSI is reset and

register is initiated, the P2OUT7 flag becomes "1" and reset is released.

NRST pin

4 clock cycles

(200 nS at a 20 MHz)

[

Chapter 4. 4-4-2 Registers ]

On this LSI, the starting mode is NORMAL mode that high oscillation is the base clock.

When the power voltage low circuit is connected to NRST pin, circuit that gives pulse for

enough low level time at sudeen unconnected. And reset can be generated even if its pulse

is low level as the oscillation clock is under 4 clocks, take notice of noise.

References

R e f e r e n c e s f o r t h e

main text.

„

„

„

„

„

Advertising
This manual is related to the following products: