Panasonic MN101C77C - Manual (Page 467)

Operation
Chapter 14 Automatic Transfer Controller
XIV - 29
13
14-3-16 Transfer Mode B
In transfer mode B, ATC1 automatically transfers one byte of data from any memory space to any other
memory space every time an ATC1 activation request occurs.
Set the source address in 18-bit memory pointer 1 (AT1MAP1H, M, L), and set the destination address
in 18-bit memory pointer 0 (AT1MAP0H, M, L).
Transfer mode B does not have an incrementing function for the memory pointers. The data transfer
executes for a fixed address.
Set the data transfer count for ATC1 in the transfer data counter (AT1TRC). The counter can be set to a
maximum of 255 transfers. The counter decrements each time ATC1 is activated. When it reaches x'00',
an interrupt (ATC1IRQ) occurs and the automatic transfer ends.
AT1MAP0
AT1MAP0 + 1
AT1MAP0 + 2
AT1MAP0 + 3
Memory Pointer 0
00000 - 3FFFF
AT1MAP1
AT1MAP1 + 1
AT1MAP1 + 2
AT1MAP1 + 3
Memory Pointer 1
00000 - 3FFFF
Figure 14-3-13 Transfer Mode B