Panasonic MN101C77C - Manual (Page 540)

Chapter 18 Flash EEPROM
XVIII - 16 Onboard Serial Interface Programming Mode
Pins
V PP : 5.0 V power supply (for Flash EEPROM)
V DD : MN101CF77G: 2.7 V to 3.6 V power supply (for Flash EEPROM and internal circuits)
NRST : Reset
P53 : Data I/O pin for communication
P54 : Clock input pin for communication
V SS : Ground
Serial
Writer
(Connector)
VPP
VDD
VSS
MN101CF77G
P53
NRST
Target Board
VDD
P53
NRST
P54
VPP
VSS
7
4
1
3
9
2
6
10
Recommended Connector
HIROSE ELECTRIC CO., LTD: Straight type pin hedder
P/N: HIF3FC -10PA- 2.54DSA 9
10
1
2
P54
Figure 18-6-3 Target Board for programming using the PanaX Serial Writer
18-6-3 Circuit Requirements for the Target Board
(in Clock Synchronous Communication using the PanaX Se-
rial Writer)
In programming Flash EEPROM using the PanaX serial writer, you need not to write load program in
advance and also be able to use all space of the Flash EEPROM as user program area.
Use P53, P54 for communication with serial writer.
This section describes the circuit requirements for the target board for onboard serial programming in
clock synchronous communication using the PanaX Serial Writer.