Nortel Networks Modular ICS 4.0 - Manual (Page 56)

44 / Answering calls
Modular ICS 4.0 System Coordinator Guide P0881591 Issue 01
2. Take the held call off hold. This is not necessary for the
M7100 telephone.
Removing yourself from a conference
ƒ‡‚
You can remove yourself from a conference, and connect the
other two callers through your Norstar system.
Enter the Transfer feature code
ƒ‡‚.
When you remove yourself from a conference using the
Transfer feature, and both callers are from outside your
system, one of the callers must have called you on a disconnect
supervised line, or the call is be disconnected.
Displays
You are trying to add a fourth party to your
conference call, or to join two conferences
together. Release one call from the
conference before adding another, or keep
the two conferences separate.
You have put a conference call on hold.
You have tried to make a conference call, but
your system is already handling its maximum
number of conference calls.
You are on a conference with the two lines or
telephones shown. You can drop out of the
conference and leave the other two parties
connected (Unsupervised Conference) by
pressing
TRANSFER or entering the Transfer
feature code.
You have activated the Conference feature
with one call active and another on hold.
Press the line of the call on hold to bring that
person into the conference.
For other displays, see “Common feature displays” on page 203.
3 parties only
Conf. on hold
Conference busy
Line001 221
TRANSFER
Press held line
p0881591.book Page 44 Wednesday, August 19, 1998 6:43 PM