Ricoh AP1400/AP2000 - Manual (Page 103)

Type 1 Printer: Loading Paper and Other Media
83
9
A
Pull the paper tray out until it
stops. After that, lift it slightly,
then pull it out of the printer.
Note
❒ Do not touch the three white
pins on the right front side of
the printer.
B
Adjust the paper size dial to
match the size and feed direction
of paper in the paper tray.
Important
❒ If you want to use paper sizes or
feed directions that are not list-
ed on the paper size dial, adjust
the dial to “
p”. In this case, you
should specify the paper size
using the operation panel.
⇒
P.125 “Making Printer Settings
with the Operation Panel”
C
Adjust the rear and side guides to
the paper size you want to load.
D
Load paper into the paper tray
with the print side up.
Important
❒ Make sure the top of the stack is
not higher than the limit mark
inside the tray.
❒ Make sure the paper fits under
the rear guide.
E
While lifting the front side of the
tray, place the tray into the print-
TS3Y150E
3 A
TS3Y160E
TS3Y170E
TS3Y180E