Ricoh AP1400/AP2000 - Manual (Page 322)

Windows NT Configuration
26
5
TCP/IP Required Components
The Windows NT system performing the NIB configuration must have the
TCP/IP protocol installed. The following steps describe how to check for and,
if necessary, add the required TCP/IP components.
Windows NT4.0
A
Click on the Windows [Start] button; select Settings and Control Panel.
B
Double click on Network and select the Protocols tab.
If TCP/IP Protocol is not in the list of Network Protocols, click on Add to in-
stall it.
C
Select the Services tab.
If either Microsoft TCP/IP Printing or Simple TCP/IP Services is not on the
list of Network Services, click on
[Add] to install them.
D
Click on [Close] when all protocols and services have been added.
If the TCP/IP protocol has just been added, Windows will prompt for the IP
address and other TCP/IP parameters.
The new protocols and services will not be available until the system is re-
started.