Ricoh AP1400/AP2000 - Manual (Page 142)

Troubleshooting
122
10
paper tray into the printer until it
stops.
I
Insert the plug of the power cord
into the wall socket securely.
Connect all of cables that were re-
moved in step
B.
Note
❒ Follow the same procedure to
clean the paper feed roller of the
optional tray unit.
J
Turn the printer's power switch
on.
Cleaning the Registration
Roller (Type 1 Printer only)
If the registration roller becomes
dirty, misfeeds might occur. In this
case, clean the roller as follows:
R
WARNING:
R
CAUTION:
Note
❒ Please refer to the inside of the
front cover of this manual to con-
firm which printer (Type 1 Printer
or Type 2 Printer) you have.
A
Turn the printer's power switch
off.
B
Open the front cover by pulling
the front cover release buttons.
C
Clean the three rubber parts of
the rollers with a soft damp cloth.
After wiping them with a damp
cloth, wipe them with a dry cloth
to remove the water.
Important
❒ Do not use chemical cleaner or
organic solvent such as thinner
or benzene.
• Make sure to turn off the print-
er's power switch and wait for
about 30 minutes before clean-
ing the registration roller. Not
waiting for the printer to cool
down can result in a burn.
• The inside of the machine could
be very hot. Do not touch the
parts with a label indicating the
“hot surface”. Otherwise, it could
cause a burn.
TS4Y100E
TS3H060E
TS3H090E