Ricoh AP1400/AP2000 - Manual (Page 138)

Troubleshooting
118
10
Type 2 printer
R
CAUTION:
Note
❒ Please refer to the inside of the
front cover of this manual to con-
firm which printer (Type 1 Printer
or Type 2 Printer) you have.
A
Pull the paper tray out of the
printer.
B
Place the tray on a flat surface. Re-
move paper from the paper tray.
C
Clean the friction pad (gray or
brown part) with a soft damp
cloth. After wiping it with a damp
cloth, wipe it with a dry cloth to
remove the water.
Important
❒ Do not use chemical cleaner or
organic solvent such as thinner
or benzene.
D
Load paper with the print side up
into the paper tray. Insert the pa-
per tray into the printer until it
stops.
Note
❒ If misfeeds or multi-feeds of pa-
per occur after cleaning the fric-
tion pad, contact your sales or
service representative.
❒ Follow the same procedure to
clean the friction pad of the op-
tional tray and the envelope
feeder.
Cleaning the Paper Feed
Roller
If the paper feed roller becomes dirty,
misfeeds might occur. In this case,
clean the roller as follows:
• The paper tray does not have a
stopper. When pulling it out, be
careful not to pull it strongly. If
you do, the tray might fall and
cause personal injury.
TS4Y270E
TS4Y280E
TS4Y100E